Studiospares S1005 Condenser Mic Bundle 2

Availability: Discontinued

SKU
449562
  • The S1005 is a great microphone for musicians and engineers that are looking to capture vocals, piano and more.
  • With a full-range frequency response, this microphone is great at capturing many instruments.
  • The new RED50 is an entry-level mic filter offering a significant improvement in clarity when recording vocals. With a simplified design that is quick and easy to set up, the RED50 is also lighter than other alternatives.
  • A realistically priced microphone stand manufactured to a standard, not a price. This stand is fully functional and finished in matt black.
  • XLRs are die-cast and have no screws. The cable is compressed by the chuck principle when the top is tightened.
Our price £100.99

Inc VAT

** Disclaimer: The next shipment the RED50 contains a new model, the photos on this page do not accurately reflect the new version. Any orders placed now will be fulfilled by the 2022 version. The specification and application will remain consistent. **

S1005 Large Diaphragm Condenser Microphone


The S1005 is ideal for musicians seeking the highest quality to faithfully capture vocalists, stringed, and wind instruments. Large diameter true condenser microphones are the only answer.

 

Features:

  • 1” Gold sputtered Capsule reacts to the slightest nuance of sound
  • Capsule artificially aged to maintain rigid specification
  • Frequency response extends down to 20Hz, well below audibility
  • Flat response from 20Hz - 20kHz with a slight presence rise at 12kHz
  • Presence rise at 12kHz provides greater clarity and cuts through the mix
  • Mesh Pop Blast filter made of cooper for ultimate screening against Interference
  • J.FET Pre amp front end for the lowest possible noise platform
  • J.FETs high impedance circuitry does not modify or change sounds captured by the capsule
  • Cardioid Response held within very tight limits to exclude unwanted side and rear sounds
  • The transformer output is more expensive but guarantees no interference on long cables
  • Complete with an Elastic Suspension the ultimate answer isolates against floor borne noise
  • Included Foam windshield which suppresses wind noise
  • 48 volt Phantom Powering.

 

Specification:

  • Pickup Pattern Cardioid,
  • 1” diameter dual Gold sputtered capsule,
  • Maximum SPL 125dB@1kHz  0.5% distortion
  • Equivalent Noise ≤20dB (A weighted)
  • Sensitivity -38dB +2dB (0dB =1V/Pa @1000Hz)
  • Frequency range 20Hz - 20kHz
  • Signal/noise ratio 76dB
  • Impedance ≤ 250Ω
  • Powering 48volt phantom power
  • Weight 0.5kg.

 

This series has been developed and refined for over two decades and represents the ultimate in large diaphragm microphone design and stands favourable comparison with products costing five times the price.

We recommend that customers try this microphone if they are looking for an inexpensive alternative to the more renowned brands. It provides an excellent quality of sound at an affordable price. You will probably look no further.

SEE INCLUDED PRODUCTS FOR DETAILED BUNDLE CONTENTS

 

RED50 Microphone Filter

The new RED50 is an entry-level mic filter offering a significant improvement in clarity when recording vocals. With a simplified design that is quick and easy to set up, the RED50 is also lighter than other alternatives, making it a highly portable solution you can take anywhere.

  • Adjustable both horizontally and vertically, making it simple to get the perfect setup whether you're using a large or small microphone
  • Comes with a clamp to attach the RED50 to a mic stand
  • Dimensions 500 x 380 x 260 mm

 

Studiospares Microphone Stand without Boom

A realistically priced microphone stand manufactured to a standard, not a price. This stand is fully functional and finished in matt black. This stand works perfectly with the Studiospares RED50 Microphone Filter and can later have a boom attached if purchased separately.

Manufactured to the ISO9002 standard.

 

Standard XLR Male - Female Lead 5m

One of our range of popular economy XLR and jack leads. XLRs are die-cast and have no screws. The cable is compressed by the chuck principle when the top is tightened. A 64 strand x0.12mm lapped copper screen ensures excellent flexibility and screening. Low DC losses are ensured by the use of 20 strands of 0.12mm copper wire.

Specification
Specifications
  • Microphone Response: 20Hz - 20kHz
  • Microphone Maximum SPL: 130dB
  • Microphone Powering: +48 Volts (Phantom Power)
  • Microphone Pad Switches: None
  • Microphone Connector: XLR
  • Microphone Capsule: Condenser
  • Physical Weight: 0.5kg
You may also like!