Furman M10LX E Merit Power Conditioner
A Merit Series Power Conditioner is the perfect low-cost AC power solution for any rack mount system. Install an M-10Lx E into the top slot of your rack, and the ten switched outlets in the rear panel will power up and protect all your equipment up to a 10-amp load. The M-10Lx E features two slide-out, swivelling light fixtures to provide discreet illumination of your equipment on stages, in studios, and in other dark places. A dimmer knob lets you adjust the lamp brightness to just the right level.
M-10X, version without the additional rack light is also available.
You have a rack for your effects, preamps, and tuner, and you are going to plug it into the wall. However, a single big spike could cause your rig to go up in smoke. Furman's standard-level surge/spike protection can defend your gear from the spikes and surges that are so common at gigs and practice spots. Additionally, with Furman's standard-level RFI/EMI filtration, you will get a quieter tone without pops, crackles, and interference from the local radio station coming out of your amp. Furthermore, the dual pull-out lamps (M-10Lx E) will allow you to see your rack without turning on the house lights.
If you can't track down where that noise is coming from or if your mix sounds flat, Furman's standard-level RFI/EMI filtration can help. It can lower the noise floor caused by the dirty AC power coming into your console or DAW. Furman's standard-level surge and spike protection can also keep your sensitive digital equipment from acting up or getting damaged due to everyday spikes and surges. With a 10A capacity and a total of eleven outlets, it's sufficient to power your entire home studio.
Bars, clubs, and other event venues often have some of the worst power out there. The AC power can be a strain on the circuits in your rig due to air compressors turning on and off and light shows pulling current loads up and down. Furman's standard-level protection and filtration can help keep the bad stuff out.
When you're out there gigging, you never know what kind of power you're going to get. The wear and tear on mobile rigs eventually takes its toll, that's why it's smart to plug into Furman's standard-level protection and RFI/EMI filtration. It keeps your equipment safe and sounding clean. Whether you're setting up a show at the local club or powering up the church band for their next service, make sure you give them power they can trust.