Furman M10X E Merit Power Conditioner

Furman M10X E Merit Power Conditioner

A Merit Series Power Conditioner is the perfect low-cost AC power solution for any rack mount system. Install an M-10x E into the top slot of your rack, and the ten switched outlets in the rear panel will power up and protect all your equipment up to a 10-amp load.

M-10Lx E, version with additional rack light is also available.

Applications

INSTRUMENT RIGS

You have a rack for your effects, preamps, and tuner. You are going to plug it into the wall, but one big spike could cause your rig to go up in smoke. Furman's standard-level surge/spike protection can defend your gear from the spikes and surges that are so common at gigs and practice spots. Additionally, with Furman's standard level RFI/EMI filtration, you will get a quieter tone without pops, crackles, and interference from the local radio station coming out of your amp. Furthermore, the dual pull-out lamps (M-10Lx E) will allow you to see your rack without turning on the house lights.

RECORDING

If you can't track down where that noise is coming from or if your mix sounds flat, Furman's standard-level RFI/EMI filtration can help. It can lower the noise floor caused by the dirty AC power coming into your console or DAW. Furman's standard-level surge and spike protection can also keep your sensitive digital equipment from acting up or getting damaged due to everyday spikes and surges. With a 10A capacity and a total of eleven outlets, it's sufficient to power your entire home studio.

DJ EQUIPMENT

Bars, clubs, and other event venues often have some of the worst power out there. The AC power can be a strain on the circuits in your rig due to air compressors turning on and off and light shows pulling current loads up and down. Furman's standard-level protection and filtration can help keep the bad stuff out.

PRO AUDIO

When you're out there gigging, you never know what kind of power you're going to get. The wear and tear on mobile rigs can eventually take its toll. That's why it's smart to plug your equipment into Furman's standard-level protection and RFI/EMI filtration, which can help keep your equipment safe and sounding clean. Whether you're setting up a show at the local club or powering up the church band for their next service, make sure you give them power they can trust.