SE Electronics X1a Condenser Mic
With a newly-developed condenser capsule and an exterior based on the rugged metal chassis of the X1, the X1 A offers first-class sound & specifications at an even better "home studio" cost, featuring an extremely natural frequency response, massive SPL-handling capabilities (150dB!), switchable attenuation and low-cut filters, and a perfectly balanced sensitivity level - so it's at home on absolutely any source.
The X1A eliminates the need for an external pop filter, and provides an extra layer of safety and security for the all-important capsule.
The -20 dB pad switch on the left provides extended dynamic range, enabling a wide range of applications and close-mic techniques for even the loudest instruments...think super-heavy electric guitars, fortissimo brass instruments, and heavy-footed kick drums.
On the right, the 100 Hz low-cut switch helps eliminate low-frequency rumble or footfall noise, and compensates for excessive bass with close-mic techniques (proximity effect).
The X1 A comes complete with a rock-solid, newly designed swivel mic clip and thread adapter to fit with any mic stand.
If you need additional rumble control, the X1 A integrates perfectly with sE's Isolation Pack, as well as the Reflexion Filter X - recommended for an instant pro vocal recording setup for your home studio.
- Capsule Type: 2/3" Permanently-Biased Condenser
- Directional Pattern: Cardioid
- Frequency range: 20 Hz - 20 kHz
- Impedance: <50 Ohms
- Sensitivity: 20 mV/Pa (-34 dB)
- Max SPL: 130 / 150 dB (0 / 20 dB pad, (0.5% THD @ 1kHz)
- Signal to Noise Ratio: 78 dB(A)
- Equivalent Noise Level: 16 dB(A)
- Dynamic Range: 114 / 134 dB (0 / 20 dB pad)
- Low Cut Filter: 100 Hz, 6 dB/oct, switchable
- Attenuation Pad: 20 dB, switchable
- Connectivity: 3-pin male XLR
- Power requirement: 48V phantom according to IEC 61938
- Recommended Load Impedance: >1K Ohms
- Current Consumption: 4.0 mA
- Diameter: 58 mm (2.28 in.) x Length: 169 mm (6.65 in.)
- Weight: 390 g / 13.8 oz
- X1 A microphone
- Swivel mic clip
- Mic stand thread adapter