Availability: Discontinued
Behringer Europower EP4000 Power Amp
The rear panel of every EUROPOWER EP4000 sports an array of options to help you get the most out of your amp. The built-in Clip Limiter automatically senses when the amplifier is being driven into “clipping” and momentarily reduces the input level to avoid distortion. This all happens in mere micro-seconds, making it the ideal way to ensure perfect sound all the time.
Stage vibrations, mic thumps and wind noise can cause ultra-low frequency sounds, or infrasonics – and while technically inaudible, they can be a real drain on power resources. As a solution, the EP4000 features a defeatable Low Cut Filter that eliminates frequencies below either 50 or 30 Hz (depending on your PA system’s capabilities) – for better sonic performance, as well as the ultimate in loudspeaker protection. The rear panel also contains the Stereo or Bridge (mono) mode switches.
Features
- 2 x 2,000 Watts into 2 Ohms; 2 x 1,400 Watts into 4 Ohms; 4,000 Watts into 4 Ohms (bridge mode)
- ATR (Accelerated Transient Response) technology for ultimate punch and clarity
- Switchable limiters offer maximum output level with reliable overload protection
- Detented gain controls for precise setting and matching of sensitivity
- Precise Power, Signal and Clip LEDs to monitor performance
- XLR and 1/4" TRS input connectors for compatibility with any source
- Professional speaker connectors and "touch-proof" binding posts support most speaker wiring systems
- Selectable low-frequency filters remove damaging infra-sound frequencies
- Independent DC and thermal overload protection on each channel automatically protects amplifier and speakers
- High-current toroidal transformer for ultra-high transient response and absolute reliability
- "Back-to-front" ventilation system including air filter for reliable operation
- "Built-like-a-tank," impact-resistant, all-steel 2U rackmount chassis