An ingenious and well engineered all metal clamp for securely mounting a microphone to either a table or a vertical or horizontal pole.
Two knobs are shown.
When the upper knob is undone, the threaded 5/8” metal spigot that screws into the mic holder can be withdrawn from the vertical position and located in the horizontal hole. This allows the axis of the microphone to change through 90 degrees. When a mic holder is screwed to the spigot, the microphone may not align in the desired direction. Just slacken the screw and rotate the spigot such that the mic is correctly orientated.
The lower knob is an Allen Key which secures a square machined block. Slackening the allen key allows the block to be turned such that the clamp can be firmly secured to a flat surface or a pole.
This allows a microphone to be mounted in any position from a table top or pole.
Maximum table thickness 44mm.
**Please note - bracket only - mic clip sold seperately.**