Availability: Discontinued
- The Short Mic Stand and Telescopic Boom (6 Pack) by Trojan Pro are equally at home in the studio or on stage.
- Perfect for recording instruments.
- The boom arm can be removed or set at any length or angle, height is adjustable between 560mm - 800mm.
- The boom arm is 910mm long extended reducing to 580mm retracted.
- The folding legs are long enough to provide good stability should a heavier microphone be used with the boom arm extended.
- The boom arm angle is easily set by an all-metal tommy bar, not a plastic knob.
- For durability, the base unit and telescopic height adjusting sleeve are die-cast metal, not plastic.
- This is a full-function stand finished in black.
Short Mic Stand and Telescopic Boom (6 Pack) by Trojan Pro
Equally at home in the studio or on stage. This Short Mic Stand is primarily used for miking instruments where the subject is closer to the floor, perfect for guitar and bass amplifiers and drums. This is a full-function stand, stylishly finished in black.
Main Features
The boom arm can be removed or set at any length or angle. Height is adjustable between 560mm - 800mm. The boom arm is 910mm long extended reducing to 580mm retracted. The folding legs are long enough to provide good stability should a heavier microphone be used with the boom arm extended. The end of the boom arm is threaded 5/8” and is supplied with a 5/8” to 3/8” thread adaptor so both standards are catered for. The thread between the stand upright and boom arm is 5/8”.
Built with durability in mind, the boom arm angle is easily set by an all-metal tommy bar, not a plastic knob. The base unit and telescopic height adjusting sleeve are die-cast metal, not plastic. When tightened, screws do not gouge marks in metalwork.
Spares for items that may get lost:
- 648130 Base screw. (The casting that all legs are attached to)
- 648140 Stand Cable Clip. (Keeps the microphone cable down to floor level)
- 648150 Boom Arm Extension Screw. (Locks the telescopic part to the static part)
- 648160 Boom Arm Locking Screw (Locks the position of the boom arm to the swivel assembly)
- 648170 Boom Arm Cable Clip. (Dresses the microphone cable along the boom arm)
Key Features:
- Die-Cast metal base
- Boom angle set by a Tommy Bar not a plastic knob Telescopic Boom Arm Setting screws do not gouge paintwork Leg hinge metal, not plastic Matte Black Powder coat finish Boom Arm threaded 3/8” and 5/8”
- Quality thick rubberised feet
Available as a Single:
Specifications |
|
---|